Central Extract Ventilation Kit in a Box

Excellent value for houses with up to 5 extract points (wet rooms, eg:- kitchen, utility room. bathroom, en-suite and WC). The Kit in a Box consistis of:

• 1 x high volume extract unit (up to 370 cu m/hr)
• 1 x 125mm extract valve (for kitchen)
• 4 x 80mm extract valve (for wet rooms)
• 2 x 125mm flexible duct (6m long)
• 4 x 80mm flexible duct (6m long)
• 1 x 125mm louvred wall grille (available in terracotta, white or brown)
• 1 x 350mm length of 125mm rigid duct (to go through exterior wall)
• 1 x 5m roll of duct tape
• 10 x cable ties
• 1 x control switch

Special Introductory Price: only £197.50 plus carriage & VAT

Buy online or ring 01491 83 66 66 to order

Click here to download the specification sheet for this kit

Helpful tip: If you are building a new house, then we strongly advise that you make provision for ducting the ventilation system to the exterior while the the building is under construction. This greatly simplifies the installation of this item, as it avoids having to cut a 125mm hole in the wall at a later stage, and probably when the scaffolding has been removed. There are 3 common ways to do this.

1. Build the wall vent grill and a short length of 125mm rigid duct  into the wall as it is being constructed. 
2. Fit the vent grills into the soffit board with a length of flexible ducting
3. Alternatively, fit a roof vent tile, with the appropriate connection, to the roof while it is being tiled. The roof vent is normally a spigot with a coloured cowl on top and 500x500mm lead skirt. Cowl available in Terracotta (orange/red), Red (brick red) Sepia (brown) and Charcoal (dark grey)

Wall grills, ducting and roof vent tiles are available separately from CVC Direct.

Roof vent tiles are available as a special order to match specific types of tile. Send details of the tile to be used.

 Copyright © 2003-10 CVC Direct Ltd. All Rights Reserved.